Xiaomi SCWXCQ02ZHM Manual Del Usuario página 7

Care & Maintenance
Cleaning the HEPA Filter Assembly
1. Place the vacuum securely on a flat surface, then turn the HEPA
filter assembly cover in the direction indicated and remove the
HEPA filter assembly.
Note:
Remove the built-in foam pad before cleaning the HEPA filter assembly. Rinse the HEPA
filter and foam pad with water.
2. Rinse the HEPA filter and foam pad with water. To thoroughly
remove all dust caught in the filter, rotate the HEPA filter by 360
degrees while rinsing. Lightly tap the filter against a sink several
times to remove any excess debris. Keep the HEPA filter in a
well-ventilated and cool place to fully dry.
Note: Fully dry the filter (at least 24 hours) before reinstalling it.
24h
11
Cleaning the So Roller Brushbar and Electric Mite
Brush
Note:
To prevent injury from accidentally turning on the vacuum, make sure the soft roller brushbar
or electric mite brush is detached from the vacuum before removing the head. The mite
brush and soft roller brushbar contain electrical components, and the soft roller brushbar
head also contains bearings. Do not wash these parts with water. Be careful of sharp objects
when removing debris caught in the heads of mite brush and soft roller brushbar.
Clean the So Roller Brushbar
1. Push the brushbar head release button in the direction of the
arrow until the cover of the brushbar head pops to open, then
remove the brushbar head by lifting it in the direction indicated.
2. After you have finished cleaning soft roller brushbar, reinsert it
by following the disassembly steps in reverse.
Clean the Electric Mite Brush
1. Use a coin as illustrated to rotate the lock counterclockwise
until you hear a click.
Note: It is recommended to clean the electric mite brush after each use.
2. After unlocking the brush head, remove it from the electric mite
brush, then rinse and clean the brush head.
3. Stand the brush head upright in a well-ventilated area for at
least 24 hours until it is fully dry.
24h
4. Once the soft roller brushbar is dry, reinstall it by following the
disassembly steps in reverse.
12