Rear Panel; Installation And Connections; Installation Procedure - PIONEER DJ DM-40 Instrucciones De Utilizacion

Rear panel

1 INPUT 1 terminals (stereo)
These are RCA pin type unbalanced input terminals.
2 INPUT 2 terminals (stereo)
This is a 3.5 mm stereo mini plug type unbalanced input terminal.
3 Speaker connection connectors
Connect the left and right speakers using the included cord.
Do not connect these speakers to an amplifier other than that of this
system. Doing so may cause a damage or fire.
4 POWER switch
Turns this unit's power on and off.
5 AC IN
Connect the power cord to AC IN and then to the power outlet.
Connect the power cord after all the connections between devices
have been completed.
Be sure to use the included power cord.

Installation and Connections

Installation Procedure

A speaker's playback sound is delicately influenced by conditions in
the listening room. To produce optimum listening conditions, take due
consideration of the conditions of your installation location before begin-
ning actual installation.
! Place the speakers at ear level.
! For a natural stereo effect, the right and left speakers should be
installed in symmetrical and equidistant positions from the listening
position.
6
En
1
2
3
4
5
CAUTION
The POWER switch on this unit will not completely
shut off all power from the AC outlet. Since the power
cord serves as the main disconnect device for the
unit, you will need to unplug it from the AC outlet to
shut down all power. Therefore, make sure the unit
has been installed so that the power cord can be
easily unplugged from the AC outlet in case of an
accident. To avoid fire hazard, the power cord should
also be unplugged from the AC outlet when left
unused for a long period of time (for example, when
on vacation).
CAUTION
This product is provided with an auto standby function.
If a state of no sound continues for a set time (approximately 25
minutes) during use, the product automatically turns off the POWER
indicator and enters a standby state with low power consumption.
When an audio signal is input in the standby state, the product auto-
matically enters the power-on state.
This auto standby function cannot be disabled.
D3-4-2-2-2a*_A1_En