4-4-4.Cable Identification On Installed Video Cable - Temper KCM-RJ-0767493 Instrucciones De Operación

VDV Wire Tester

4-4-4.Cable Identification on Installed Video Cable

• The remote ID's can be used to identify cable runs from the patch panel to a wall port, each
identifier has a labeled ID number.
• When the tester is connected to a cable that has an identifier attached at the other end, the
tester will display the ID number that is marked on the identifier.
1.Connect the numbered remote ID's to the F connector port for each location that needs to be
identified.
2.At the patch panel, connect the unknown cable to the F port on the tester.
3.Press ON/OFF Button to turn on the tester, and then press Video
video cable test function.
4.If the cable being tested is connected to one of the remote Id's, the display will indicate the
number that corresponds to the remote.
Note: The open or short indicator will appear if the cable is defective.
F-Connector
Remote Identifier:
5 remotes
(numbered 1- 5)
24
Button to select the