Dometic WAECO PerfectView VS 400 Instrucciones De Montaje Y De Uso página 26

Safety and installation instructions
Observe the following installation instructions:
CAUTION!
!
 Secure the parts installed in the vehicle in such a way that they
cannot become loose under any circumstances (sudden brak-
ing, accidents) and cause injuries to the occupants of the
vehicle.
 Secure any parts of the system covered by the bodywork in
such a manner that they cannot be come loose or damage other
parts and cables or impair vehicle functions (steering, pedals,
etc).
 Always follow the safety instructions of the vehicle manu-
facturer.
Some work (e.g. on retention systems such as the AIRBAG etc.)
may only be performed by qualified specialists.
NOTICE!
A
 To prevent damage when drilling, make sure there is sufficient
space on the other side for the drill head to come out.
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
NOTICE!
A
 When testing the voltage in electrical cables, only use a diode
test lamp or a voltmeter.
Test lamps with an illuminant take up voltages which are too
high and which can damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders
or insulating tape, for example to existing cables.
26
All manuals and user guides at all-guides.com
VS400
EN