Connecting The Controller - Dometic WAECO PerfectView VS 400 Instrucciones De Montaje Y De Uso

Connecting electrical power to the video splitter
7.2

Connecting the controller

➤ Connect this connection (fig. 6 1, page 5) to the controller.
➤ Connect this connection (fig. 6 2, page 5) to the monitor.
➤ Connect the cable set (fig. 5 3, page 4) to the plug of this connection
(fig. 6 3, page 5).
7.3 Connecting the cable set
The cable set features the following connections:
No. in
fig. 0, page 6
1
2
3
4
5
6
7
➤ Connect the camera connections (fig. 0 1, page 6) to the cameras.
➤ Connect the red cable (fig. 0 2, page 6) to the positive wire (+) of the
vehicle.
➤ Connect the black cable (fig. 0 3, page 6) to the earth wire (–) or to earth
(bodywork).
➤ Connect the green cable (fig. 0 4, page 6) to the positive wire (+) of the
reversing light (camera 1).
➤ Connect the white cable (fig. 0 5, page 6) to the control signal for
camera 2.
➤ Connect the blue cable (fig. 0 6, page 6) to the control signal for
camera 3.
➤ Connect the brown cable (fig. 0 7, page 6) to the control signal for
camera 4.
32
All manuals and user guides at all-guides.com
Explanation
Connections for camera 1 – 4, 6-pin, protected from jets of
water
12 V connection +, red
Earth connection –, black
Control input for reversing light (camera 1), green
Control input for camera 2, white
Control input for camera 3, blue
Control input for camera 4, brown
VS400
EN