Installing The Video Splitter; Tools Required - Dometic WAECO PerfectView VS 400 Instrucciones De Montaje Y De Uso

VS400
6

Installing the video splitter

6.1

Tools required

For installation and assembly, you will need the following tools:
 Drill bit set (fig. 1 1, page 3)
 Electric drill (fig. 1 2, page 3)
 Screwdriver (fig. 1 3, page 3)
 Set of ring or open-ended spanners (fig. 1 4, page 3)
 Measuring ruler (fig. 1 5, page 3)
 Hammer (fig. 1 6, page 3)
 Centre punch (fig. 1 7, page 3)
To establish and test the electrical connection, the following tools are re-
quired:
 Diode test lamp (fig. 1 8, page 3) or voltmeter (fig. 1 9, page 3)
 Crimping tool (fig. 1 10, page 3)
 Insulating tape (fig. 1 11, page 3)
 Cable bushing sleeves (optional)
To secure the controller and the cables, you may require additional
screws and cable binders.
CAUTION!
!
Select the location of the modules so that they cannot injure the
passengers in the vehicle under any circumstances (e.g. sudden
braking, road traffic accidents).
Observe the following installation instructions:
 The installation location must be protected from moisture and be inside
the vehicle.
 The installation location should be level.
 Before drilling each hole, ensure there is sufficient space on the other side
for the drill head to emerge (fig. 2, page 4).
EN
All manuals and user guides at all-guides.com
Installing the video splitter
29