8. LCD Display
05
The throttle has fault
07
Overvoltage protection
08
Error with the hall sensor
signal inside the motor
09
Error with the Engine phase's
10
The temperature inside
the engine has reached its
maximum protection value
11
The temperature sensor
inside the motor has an error
12
Error with the current sensor
in the controller
13
Error with the temperature
sensor inside of the battery
14
The protection temperature
inside the controller has
reached its maximum
protection value
15
Error with the temperature
sensor inside the controller
21
Speed sensor Error
25
Torque signal Error
26
Speed signal of the torque
sensor has an error
27
Overcurrent from controller
30
YOU-RIDE MONT BLANC
1. Check the connector of throttle whether they are
correctly connected.
2. Disconnect the throttle, If the problem still
occurs, please contact your retailer.
(only with this function)
1. Remove the battery.
2. Re-Insert the battery.
3. If the problem persists, please contact your
retailer.
Please contact your retailer.
Please contact your retailer.
1. Turn off the system and allow the Pedelec to cool
down.
2. If the problem persists, please contact your
retailer.
Please contact your retailer.
Please contact your retailer.
Please contact your retailer.
1. Turn off the system and let the pedelec cool
down.
2. If the problem persists, please contact your
retailer.
Please contact your retailer.
1. Restart the system
2. Check that the magnet attached to the spoke is
aligned with the speed sensor and that the distance
is between 10 mm and 20 mm.
3. Check that the speed sensor connector is
connected correctly.
4. If the error persists, please contact your retailer.
1. Check that all connections are connected
correctly.
2. If the error persists, please contact your retailer.
1.Check the connector from the speed sensor to
make sure it is connected correctly.
2.Check the speed sensor for signs of damage.
3.If the problem persists, please contact your
retailer.
Please contact your retailer.