Technical Data - YATO YG-03006 Manual Original

The blender is stopped after releasing the pressure on the switch. You should allow to stop for rotation of the moving parts, and
then remove the attachment from the food container, then remove the plug of power cable from the mains wall socket and proceed
to maintenance.
If there are used attachments equipped with blades, at the start of the operation, we recommend that you use a lower speed and
gradually increase it in the course of work, until you achieve satisfactory work eff ects.
Lower the speed of all attachments will reduce liquid food splattering and spreading of granular products.
Maintenance of the product
ATTENTION! Before each cleaning, turn off the product, disconnect the plug of power cable from the mains wall socket. and then
wait for its cooling down and only then proceed to maintenance.
ATTENTION! We recommend that you clean the blender attachments immediately after food preparation. This will prevent the
food residues caking and will facilitate the cleaning of the product.
If, in the course of work, the driver housing become contaminated with processed food, you should stop working, clean the product
and only after that resume your work.
To clean the product, you should use only mild agents intended to clean kitchen utensils. It is forbidden to use abrasive cleaners for
example powder or cleaner milk, which is containing corrosive substances. Do not use cleaning solvents, gasoline or alcohols.
Cleaner should be diluted with water accordance to the information that came with it, then you should apply it on a soft cloth and
clean the product from inside and outside.
Residues of the cleaning agent should be removed with a soft cloth slightly soaked in clean water. Then dry all the surfaces with
a dry soft cloth.
ATTENTION! The product is not intended for cleaning with a stream of water. Do not immerse the product in water.
By using a stream of water or by immersing in water you may clean the containers with scale and the operational tip of compacting
attachment, after disconnecting it from the adapter which allows for the drive connection. The remaining elements of the product
should be cleaned only with a damp cloth.
The blade and blade guard of the mixing attachment can be cleaned with water after you disconnect the attachment from the drive,
and with care, to avoid the wetting of adapter, which allows for connecting the drive.
Before using the product again, you should dry all elements.
ATTENTION! In the case, when you prepare one dish immediately after the other, during preparation of various dishes using
the same attachment, you can get rid of the food remnants by immersing and short run of the attachment in the container with a
clean, lukewarm water.
When you are cleaning the blades, you should avoid the situation when they contact with a human body. You should wash by
using brushes or sponges.
Transportation and storage of the product
Before starting a storage or transport, you should thoroughly clean the product with the remnants of food.
Store the product indoors, protect against dust, dirt and moisture. It is recommended to store the product in the factory packag-
ing.

TECHNICAL DATA

Parameter
Catalog number
Rated voltage
Rated frequency
Rated power
Insulation class
Max. no-load speed
Working rotational speed
Net weight
Degree of protection
O R I G I N A L
10
GB
Unit
[V a.c.]
[Hz]
[W]
[min -1 ]
[min ]
-1
[kg]
I N S T R U C T I O N S
Value
YG-03006
220-240
50 / 60
700
II
16,000
12,600 – 15,000
0.6
IPX0