Product Service - YATO YG-03006 Manual Original

GB
cable. the cable must be replaced with a new one at the authorized service point.
Before assembly, disassembly or adjustment of product accessories, you should disconnect
the power plug from the wall socket. Take special care when handling the sharp parts of the
product. You should not touch any parts of which are in a motion. The blades are very sharp,
and even in the case of blades, which are still at the moment, there is a risk of injury. You
should be very careful when handling any accessories which are containing blades.
Before starting the product, you should make sure that the selected accessory is correctly
mounted.
Do not overload the product. the housing temperature should never exceed 60 C. Over-
O
loading of the product will cause its faster wear, and can also cause damage and increase
the risk of electric shock.
The product is not intended for use by children. You should keep the cable out of reach of
children. Please pay attention, that the children would not treat the product as a toy.
Children without supervision should not carry out the cleaning and maintenance of the de-
vice.
The product is not intended for use by persons with reduced physical capabilities, reduced
mental abilities and people with lack of experience and knowledge of the equipment. unless
there is provided the supervision or instruction concerning the use of appliance in a safe way,
so that the associated risks would be understood.

PRODUCT SERVICE

Preparing for operation
You should unpack the product, completely removing all the elements of the package. It is recommended to keep the packaging,
may be useful for later transport and storage of the product.
Check the product for damage. If you fi nd any damages, do not use the product before removing damages or replacing damaged
items for new ones, free from damage.
Wash the product in accordance with the instructions from the point "Product maintenance".
Mount the selected accessory in accordance with its intended purpose. The symbol of an open padlock, which is visible on top
of the accessory adapter should be directed on the arrow symbol visible on the drive. Push, and then turn the accessory so the
arrow will be pointing toward the closed lock symbol.
Make sure, the accessory has been connected correctly and it will not detach itself from the housing drive during operation.
If you use the cutting attachment, it may be used only together with the supplied container. The container should be placed only
on a fl at, level and hard surface, before using it, you should remove the attachments handle and make sure that the the container
lid has been completely closed.
Mixing attachment is used for grinding fruit and vegetables, for preparation of sauces, mixing liquids, for example. soups, creams, etc.
The cutting attachment is used for chopping, grinding of meat and for the preparation of pastes with hard food products.
The compacting attachment is used for preparing a foam of eggs, for cream whipping, mixing rare cakes for example pancakes,
for eggs rubbing.
If the container with the scale, was delivered with the product, it can be used as a vessel for food preparation. It is also possible
to use the public available containers intended for this purpose. The cutting attachment may be used only with the supplied
container with a lid.
Product service
Without touching the switch, you should connect the power cord plug into the mains wall socket.
Enter the end of the attachment to a container with food, and then start the blender by pressing and holding the switch. The
blender is equipped with two switches: the top switch allows to work at a slower speed and the lower switch allows to work at the
maximum speed.
If you use the upper switch you can adjust rotational speed with the control knob. If you use the lower switch the blender only
operates at the maximum speed.
Operation time of the blender may not exceed 30 seconds, after that you should allow the blender to cool down for at least 3
minutes.
O R I G I N A L I N S T R U C T I O N S
9