A.E.B. 763Ni Manual De Instrucciones página 10

IS762ni REV.280600 - 0
Fitting Instructions workbook
2) Replace the flange screws connected with the slide eyelets with
the stud screws (5x45 M.A.) supplied in the package. Then fix the
slide, tightening the nuts as in the figure below.
BLACK WIRE GROUND
GREEN WIRE
WHITE WIRE
The numbers given in the drawing indicate the precise order for
assembling the various parts supplied in the package. You are
recommended to comply with them.
3) Insert the extension connector into the sensor one, then take the
cable into the motor compartment and do the connections as shown
in the diagram for fitting the changeover switch with gauge.
THE A.E.B. LEVEL SENSOR
NEEDS NO FURTHER ADJUSTMENT
1 ) Stud screw
2 ) Securing nut
3 ) Washer
4 ) Washer
5 ) Sensor
6 ) Washer
7 ) Securing nut
English
IS763Ni Rev. 280600 - 0