Uline H-8796 Guia De Inicio Rapido

H-8796, H-8797
FLAT FILE CABINET
TOOLS NEEDED
Phillips Screwdriver Flathead Screwdriver
Handle x 10
M6 Nut x 2
HANDLES AND LABEL HOLDERS
1. Place handle on front of drawer and insert two
M4 x 6 mm handle screws with two M4 washers
through opposite side. Tighten using a Phillips
screwdriver. Repeat for all drawers. (See Figure 1)
Figure 1
2. Attach label holders by pushing tabs through slots in
front of drawer and bending tabs on back of drawer
toward center to secure.
STACKING
1. Remove bottom drawer (A) of top unit and top
drawer (B) of bottom unit. (See Figure 2)
NOTE: To remove drawers, pull drawers straight
out and lift up.
PAGE 1 OF 3
1-800-295-5510
uline.com
10 mm Wrench
PARTS
M6 x 55 mm Bolt x 2
Label Holder x 5
ASSEMBLY
M4 x 6 mm Screw
M4 Washer
Handle
Label Holder
Rubber Mallet
M4 x 6 mm Handle Screw x 20
Paper Label and Plastic Cover x 5
Figure 2
A
B
2. Remove knockout caps on top of bottom unit.
NOTE: Knockout caps can be removed using a
flathead screwdriver and rubber mallet. Stand
the flathead screwdriver on the knockout caps
and tap the top of the screwdriver handle with
the rubber mallet to knock the caps off.
3. Stack units and align holes at front ledge of units.
Insert M6 x 55 mm bolts into top and bottom unit.
Attach M6 nuts and tighten to secure.
Para Español, vea página 2.
Pour le français, consulter la page 3.
M4 Washer x 20
Key x 2
M6 x 55 mm
Bolt
M6 Nut
0721 IH-8796