How To Install On The Bike; Power On/Off - VDO GP7 Manual Del Usuario

WARNING!
HOW TO INSTALL
Follow these instructions for a correct installation of
ON THE BIKE
the mount on the bike:
CORRECT BIKE mOUNT PLACEmENT:
YES
INSTALLATION:
1 2
Stick the double-sided tape and then fix the rubber pad to
the back of the mount.
Place the mount on the handlebar in the position you
prefer, and fix it with the cable ties.
Switch on the device. The device is now ready to be used.
Install the cable ties in the mount.
Slide the device on the mount (trough the lead-lines
present on its back) until you hear a click.
WARNING: the cable ties and the mount hold
steady on the handlebar. The device instead can
be removed just pulling down the safety lever and
slide it out.
94
SWITCH THE DEVICE ON:
Press the on/off button constantly (for 3-5
NO
seconds), but without forcing, to switch the
device on.
VDO GP 7 is now ready to be used.
TURN THE DEVICE OFF:
Pressing the on/off button (B) while the device
is on, to:
- turn it off, terminating the current session
("Power off").
- put the device in stand-by mode ("Sleep").
- or use "Cancel" to return to the navigation
software.

POWER ON/OFF

POWER ON
POWER OFF
STAND-BY
CANCEL
95