Troubleshooting - GMC GDS115 Manual Del Usuario

Satinadora 1200 w
Ocultar thumbs Ver también para GDS115:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 54

Troubleshooting

Problem
No function when On/Off Trigger Switch (5) is
operated
Slow material removal
Scratches on workpiece after sanding
Burn marks on workpiece
Excessive workplace dust or swarf
Tool hot to the touch
262029_Z1MANPRO1.indd 13
All manuals and user guides at all-guides.com
Possible cause
No power
Defective On/Off Trigger Switch
Sanding drum too fine or worn
Sanding drum too coarse
Not enough material removed
Sanding drum incompatible with material
Too much pressure exerted on to the sander
Vacuum dust extraction system not used in
workplace
Cleaning frequency inadequate
Work session too long
Motor Vents (6) blocked
Work surface excessively hot
13
Solution
Check power supply
Have the On/Off Trigger Switch replaced by an
authorised Silverline service centre
Fit new sanding drum with coarser grit
Fit new sanding drum with finer grit
Continue sanding
Fit correct sanding drum
Use less pressure whilst using the tool. This will
also help reduce wear on tool and sanding drums
Fit a dust extraction system
Clean workplace and tool more frequently
Allow tool to cool before continuing
Vacuum out Motor Vents and allow tool to cool
before continuing
Allow to cool before continuing
GB
26/06/2014 09:09

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido