Notes On Operation - Blumfeldt Cascada 2G Manual

NOTES ON OPERATION

Special notes on the pump
Note: Make sure that the power cord runs lower than where the plug attaches
to the mains outlet. This prevents water from flowing along the cable into the
socket.
• To avoid electric shock, connect the plug only to a grounded socket.
• Do not change the plug.
• Check the voltage on the product label before use. Ensure that you only
connect the pump to sockets with the appropriate voltage.
• Never pump flammable liquids.
• Do not use water that is warmer than 35 °C (95 °F).
• The pump must be supplied via a residual current device (RCD) with a
rated residual operating current of no more than 30 mA.
Notes on the pump function
A clogged or dirty intake surface will significantly reduce performance. When
using the pump on a dirty surface, lift it slightly to reduce the amount of dirt
touching the inlet. If a slower flow is desired, adjust this on the flow control
lever on the side of the pump.
Do not run the pump if it is not immersed in water. This could damage the
pump. Always immerse the pump in water first before plugging it into the
socket. It is normal for there to be air in the pump and hoses when it is first
plugged in. Pull out the plug several times and plug it in again until the water
starts to flow.
EN
17