Tabla de contenido
Publicidad
food at a time.
usher to remove the blockage if the jar lid is blocked by the materials.
7.
When the measuring cup is full (max. 400 ml) or when all the food has been squeezed, turn the on/
off switch off (O) and empty the measuring cups.
nce to the power source, and then press the power switch to
Tip: Rinse all parts immediately after use.
appliance starts to work. After a few minutes, the juice flow out.
! Caution:
n the power switch from "I" to "R" or from "R" to "I" directly at
·
Never let the machine work for longer than 15 minutes at a time. A minimum rest time of 30 minutes
must be maintained between two consecutive cycles.
·
Do not touch the on/off switch with wet hands.
ation. If required, firstly press the power switch to "O" position and
·
If the cover becomes loosened from the bowl during use, the motor of the machine will automatically
stop to prevent any hazards.
top running completely and then turn the power switch from "I" to
·
Juice that is not drunk immediately should always be stored in the refrigerator.
RESET BUTTON
"I" .
The reset button must be used when the machine is automatically shut off due to overheating or blockage
of the machine.
rate the unit before feeding food to avoid damaging the grinding
1.
If the machine overheats, it will turn off automatically.
2.
Turn the machine off (O).
inding head and strainer).
3.
Wait 10 minutes and then push the reset button at the bottom of the appliance to switch the
machine on again.
your fingers or other foreign objects into the feeding opening while
4.
After that, press and hold the power switch to the "R" position for a few seconds and then try
operating again. When the reverse function does not work, turn off the machine, disassemble the
appliance and reassemble following the instructions given. After reassembly please try turning on
the machine.
f the machine is stuck and
irstly press the power
n and then press the reset
pped at the bottom of
CLEANING AND MAINTENANCE
After it, press and hold the power switch to the "R" position for few
1.
In order to detach & clean more easily, run the juicer without load for about 30 seconds after
removing the residue. If the bowl lid cannot be detached easily, please follow and repeat the
ating again. When reverse function cannot work, turn off the machine
following operation for two or three times: reverse (R) — off (O) — on (I); at the same time, hold and
rotate the bowl lid to detach it. After finish extracting juice, pour some water into the bowl lid to
wing the instructions given. After reassembly please try turning on the
clean it so that it will be easier to be detached.
2.
Remove the plug from the outlet and allow the machine to cool completely before cleaning.
3.
Remove the food pusher, then push the fastener outwards to release the bowl lid.
4.
Turn the cover loose from the bowl and disassemble the rest of the parts in reverse order of
assembly.
ntainer is full (the max capacity is 400ml) or the food has been
5.
If it is difficult to detach the squeezing screw, put the bowl on the working table and hold the
squeezing screw with one hand, then push the axis of the squeezing screw at the bottom with the
urn the power switch to the "O" position and empty the juice container
other hand to push the squeezing screw out of the bowl.
36
DO9248J
before continuing extracting.
Fig.6
Publicidad
Tabla de contenido
