Velleman VMB2BL Manual Del Usuario página 5

Idiomas disponibles

Address

The outputs will be deactivated and the UP or DOWN operation LED of the corresponding channel will blink rapidly to indicate the

learning mode. The LEDs of the learned push buttons will blink rapidly as well. You can easily detect which push buttons have been

learned for the UP or DOWN control. Add a specific push button by maintaining it pressed until the output activates. Releasing the push

button will deactivate the output while the indication LED of the push button blinks rapidly as confirmation. You can not add any more

push buttons when the maximum number of push buttons has been reached. A learned push button can be deleted by maintaining it

pressed. Releasing it will turn off the indication LED of the push button. Delete all learned push buttons of a command by maintaining

pressed the manual control on the blind control module until the output switches on. Releasing the manual control push button will

deactivate the output and turn off the indication LEDs of each corresponding push button.

Repeat the procedure above to learn other commands to the push buttons.

Exit the learning mode by resetting the address of the blind control module at the original value.

When using firmware version 0736 you will be able to delete all push buttons saved for a particular channel into the memory of the blind

control module at once. Set the address to one of the learning addresses. Maintain the manual control on the blind control module pressed

for 10 seconds. The relay will activate and deactivate again after 7 seconds to confirm the push buttons have been erased. Set the address

back to its original value.

Push buttons to learn

Learning push buttons rising shutter 1

Learning push buttons rising shutter 1 immediately and completely

Learning push buttons lowering shutter 1

Learning push buttons lowering shutter 1 immediately and completely

Learning push buttons raising and lowering the blind (as from firmware version 0805)

Learning push buttons rising shutter 2

Learning push buttons rising shutter 2 immediately and completely

Learning push buttons lowering shutter 2

Learning push buttons lowering shutter 2 immediately and completely

Learning push buttons raising and lowering the blind (as from firmware version 0805)