Functional Description - Klarstein EL PRESIDENTE Manual

• The unit performs best at an ambient temperature of 20 - 25 °C. It is
recommended to switch off the device when the room temperature is below
10 degrees.
• After plugging in the power cord, let the appliance cool down for 2 - 3 hours
before placing drinks inside the appliance.
• Be sure to provide adequate ventilation for the unit. The inner circuit board
is very sensitive and can quickly break in the event of insufficient ventilation.
Inadequate ventilation will also shorten the service life of the unit.
• If a leak occurs (can be easily detected by an unpleasant odour) proceed as
follows:
1. Switch off the device immediately.
2. Ventilate the room thoroughly.
3. Contact customer service.
• These models use a thermoelectric cooling system with automatic defrost
system, so manual defrosting is not required.
• This cooling unit is not intended for the use as a built-in unit.
• The recommended temperature control for this product is 14 degrees.
Cleaning
When using for the first time, first remove all the packaging material including the
adhesive strips. Clean the device with a soft cloth. Remove any moisture inside the
unit.

FUNCTIONAL DESCRIPTION

• This appliance is not suitable for food storage.
• This appliance is not suitable for freezing food.
• It is recommended to use this device with an operating temperature of 17 °C.
• The factory placement of the shelves is the most energy-efficient method of
use for refrigeration units.
• If the ambient temperature is exactly 25 degrees and the unit is not filled,
it will take approximately 60 minutes for the unit temperature to cool down
from 25 °C to 17 °C.
• It is recommended to use the unit at an operating temperature of 17 °C. The
energy consumption for your particular device is shown in the table below. If
the set temperature is higher than 17 °C, the energy consumption is lower. If
the set temperature is lower than 17 °C, the energy consumption is higher.
EN
23