Use; Installation - Sirius SLT955 Instrucciones Para La Instalación, Uso Y Mantenimiento

WARNINGS
* The appliance is not intended for use by
young children or infirm persons without
supervision. Young children should be su-
pervised to ensure they do not play with the
appliance.
* The air sucked can't be conveyed through
or into a duct used to let out fumes from
appliances fed by energy other than electric
power (eg. centralized heating, radiators,
water-heaters, etc.).
* To evacuate the air outlet, please comply
with the pertaining rules given by competent
authorities.
The cooker hood, when evacuating the sucked
air, could generate a negative pressure in the
room- which can't exceed the limit of 0.04
mbar, in order to avoid the suck of exhausts
deriving from the heat-source.
Therefore the room should be provided with
air-intakes to allow a constant flow of fresh
air.
* When performing the electrical connections
on the appliance, please make sure that them
current-tap is provided with earth connection
and that voltage values correspond to those
indicated on the label placed inside the ap-
pliance itself.
* Please disconnect the appliance from power
mains, before carrying out any cleaning or
maintenance operation.
If the appliance is not equipped with a non-
separable flexible cable and plug, or with an-
other device ensuring omnipolar disconnec-
tion from the mains, with an opening distance
between the contacts of at least 3 mm, then
such disconnecting devices must be provided
in the fixed installation.
If the appliance is equipped with a power cord
and a plug, it shall be placed in such a way
that the plug can be reached easily.
* The use of materials which can burst into
flames (flambé) should be avoided in close
proximity of the appliance.
When frying, please pay particular attention
to fire risk due to oil and grease.
Being highly inflammable, fried oil is espe-
cially dangerous. Do not use uncovered elec-
tric grills.
In order to avoid possible fire risk, all in-
structions for grease-filter cleaning and for
removing eventual grease deposits should be
strictly followed.
* Two persons are needed for the installation
of this product.
The product is not equipped with the duction
motor, therefore it must be coupled to a suc-
tion unit (remote motor) of the same manu-
facturer.

INSTALLATION

To install the product is necessary to make
a countertop minimum depth of at least 220
mm up to a maximum of 400 mm. For great-
er depths it is necessary to ask the special
KIT with mounting brackets for ceiling depth
from 400mm to 580mm.
Attention: If a remote motor is installed
in the same compartment as products
SLT955/SLT956, check the overall dimen-
sions of the remote motor.
You can choose the side of the hood from
which to run off the sucked air; there are air
outlets of rectangular shape on three sides
of the hood.
After choosing the best location, set up the
channel, the supply provided includes an air
outlet flange of rectangular shape 230x80mm
to be installed on the chosen outlet. Leave
closed the air exhaust holes are not used.
There is also a fitting included, that allows
the use of tubes with a diameter equal to 150
11
mm (see fig. 1), if you plan to create a circular
air outlet duct.

USE

Tig
bra
into
Pla
and
Per
spo
ets
ing
Ma
and
the
DU
If i
SLT
tric
con
SLT
Ins
tha
hoo
The
pla
- S
cur
- S
ing
Use
pla
the
We
a g