Customizing the
Appearance
Setting the distance alert
When you pass the intervals you set, this unit
sounds a beep and displays your travel dis-
tance.
! This function can be operated only when
selecting the virtual mode.
1
Touch Display.
2
Touch Distance Alert to select the de-
sired interval.
Each time you touch Distance Alert it selects
intervals in the following order:
Off (off)2km5km10km50km
100km
Note
The unit of distance can be switched between
miles and kilometers. (Refer to Setting units and
scales on page 29.)
Selecting the vehicle type
You can select the vehicle type displayed in
the virtual mode.
! This function can be operated only when
selecting the virtual mode.
1
Touch Display and
Vehicle Type.
2
Touch Vehicle Type to select the desired
vehicle type.
Each time you touch Vehicle Type it selects
vehicle types in the following order:
Vehicle A (vehicle A)Vehicle B (vehicle B)
Vehicle C (vehicle C)Vehicle D (vehicle D)
Vehicle E (vehicle E)Vehicle F (vehicle F)
Vehicle G (vehicle G)
All manuals and user guides at all-guides.com
and then touch
Customizing the graph
You can customize the graph as desired.
! These functions can be operated only when
selecting the vehicle status mode.
Selecting the graph pattern
You can switch the graph pattern between line
graph and area graph.
1
Touch Display.
2
Touch Pattern to select the desired
graph pattern.
Each time you touch Pattern it selects graph
patterns in the following order:
Line (line)Area (area)
Selecting the graph data
1
Touch Display.
2
Touch Data to select the desired graph
data.
Each time you touch Data it selects graph
data in the following order:
Speed (speed)R"P"M (RPM)ACC.G (ac-
celeration)LAT.G (lateral acceleration)
Power (power)Torque (torque)
Selecting the scale of graph
1
Touch Display.
2
Touch Scale to select the desired scale.
Each time you touch Scale it selects scales of
graph in the following order:
30sec (30 sec.)60sec (60 sec.)2.5min (2.5
min.)5.0min (5.0 min.)
Section
04
17
En