Rupes DD122 Instrucciones De Uso Y Manutención página 11

BATTERIES 9B122 - 9B142
11 - Contacts
BATTERY CHARGERS 9C122
13 - identification plate
14 - Status indicator
15 - Battery housing
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been
damaged during storage or transport;
- the tool is complete; check that the number and type of components
comply with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in the
table and that indicated on the tool identification plate reproduced and
explained on page 11.
ASSEMBLING THE TOOL
CHARGE THE BATTERY (H)
The new battery is supplied uncharged therefore it must be charged before
use. The new battery requires at least ten charge-uncharge cycles before pro-
viding the services indicated on the label.
To charge proceed as follows:
- insert the battery charger plug in the power socket;
- insert the battery in the specific housing (15) making sure that the rib on the
battery side corresponds to the groove on the battery housing;
- check that the red light (14) is on; charging is complete when the green light
goes on.
Warning: only use the battery charger in dry, clean areas away from heat
sources and flammable substances!
BATTERY ASSEMBLY (A)
Insert the battery (9) in the lower part of the handle (7) pushing upwards until
the fastening device clicks. Make sure that voltage is suitable for tool opera-
tions.
BIT AND INSERT ASSEMBLY AND DISMANTLING
DD122 - DD142 (F)
Unscrew the chuck until the jaws open wide enough to accommodate the
chosen bit or insert;
2 - tighten the chosen tool between the jaws by screwing in the chuck;
3 - make sure the tool does not rotate off-centre;
4 - follow the instructions in reverse order to dismantle.
ROTATION DIRECTION SELECTION (C)
Using the control (5) push the button towards or away from the machine body
to select the required rotation direction; the intermediate position acts as a
lock.
- Counter-clockwise rotation damages drill bit blades.
Warning: only use the control when the machine is not running!
MECHANICAL SPEED GEAR (D)
Use the control (3) to select one of the two speeds:
- position "1" - low speed
- position "2" - high speed
Warning: only use the control when the machine is not running!
TORQUE ADJUSTMENT (E)
Torque or drilling is adjusted using ring (4); torque is proportionate to the
number marked on the ring: 1= minimum; 16 (marked by bit symbol) = maxi-
mum.
Selection can be made with the machine running.
BEFORE STARTING THE TOOL
Ensure that:
- battery voltage is in accordance with machine specifications;
- the battery is firmly fastened in the handle;
- all machine components and accessories are correctly assembled.
STARTING AND STOPPING (B)
- Starting: press the switch (2); the pressure exerted on the button should be
proportionate to the number of required rotations (electronic regulation).
- Stopping: release the button (2).
11