Makita DTD152 Manual De Instrucciones página 6

Reversing switch action
A
1. Reversing switch lever
CAUTION:
Always check the direction of
rotation before operation.
CAUTION:
Use the reversing switch only after
the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may dam-
age the tool.
CAUTION:
When not operating the tool,
always set the reversing switch lever to the neu-
tral position.
of rotation. Depress the reversing switch lever from the
terclockwise rotation.
tion, the switch trigger cannot be pulled.
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing driver bit/
socket bit
12 mm
(15/32")
not use any other driver bit/socket bit.
B
1
9 mm
(3/8")
1
1. Driver bit 2. Sleeve
it will go.
1
-
1. Driver bit 2. Sleeve
-
of the arrow and pull the driver bit out.
NOTE: If the driver bit is not inserted deep enough
into the sleeve, the sleeve will not return to its original
position and the driver bit will not be secured. In this
case, try re-inserting the bit according to the instruc-
tions above.
NOTE:
the sleeve and insert it into the sleeve as far as it will
go.
NOTE:
Installing hook
1. Groove 2. Hook 3. Screw
6 ENGLISH
2
2
1
2
3