What's In The Box - Wiseup WBD100 Manual Del Usuario

All manuals and user guides at all-guides.com
II. What's in the Box
-1× Anti-Spy Detector
-1× AC110-240V to DC5V Charger
-1× Headset
III. Radio Frequency Detection
>> Before using, please make sure that the detector is fully charged.
3.1. To power on the detector, slide the Power Switch to the ON position.
3.2. Press the Mode Button once to switch to beep mode and the beep mode LED
will glow solid orange. Or you can press the Mode Button once again to switch to
vibration mode and the vibration mode LED will glow solid orange.
3.3. Push up the sensitivity wheel and extend the antenna to the longest to widen the
search scope.
3.4. If RF signals are detected, the detector will either start beeping or vibrating.
Judging by the 4 signal LEDs, you can tell how strong the RF signals are.
3.5. Gradually push back the sensitivity wheel and shorten the antenna to narrow
down to the source of the radio signal. When closest to the objects emitting RF sig-
nals, all 4 signal LEDs will come on and stay illuminated.
3.6. Power off the detector by sliding the Power Switch to the OFF position.
[Note]:
The detector is in laser LED mode by default.
IV. Camera Lens Detection
>> Before using, please make sure that the detector is fully charged.
4.1. To power on the detector, slide the Power Switch to the ON position.
4.2. All 6 laser LEDs will keep flashing.
4.3. Give the Laser Blinking Adjustment Button a short press to make the laser LEDs
flash faster.
4.4. Look through the camera detection lens and you will find a blinking red dot
where the camera lens locates at.
4.5. Power off the detector by sliding the Power Switch to the OFF position.
V. Charging
5.1. Power off the detector and connect it to an outlet AC power supply using the
included DC5V charger.