DUO
DUO X X X X X A A A A A udio Cityline
DUO
udio Cityline
udio Cityline
DUO
DUO
udio Cityline
udio Cityline
DUO
DUO X X X X X A A A A A udio Cityline
DUO
udio Cityline
udio Cityline
udio Cityline
DUO
DUO
udio Cityline
Configuration - Programming the Amplifier
The DUOX amplifier can be configured to allow for the operation
as a general entrance, block entrance or sub-block entrance.
•
The DUOX system uses 6 digit house terminal addresses.
•
These call code digits are organised as follows: BBSSNN:
- BB: indicates the Block number, (from 00 to 99).
- SS: indicates the sub-Block number, (from 00 to 99).
- NN: indicates the sub-Block house number, (from 00 to 99).
You do not have to segregate the installation according to this
hierarchy since the system adapts to the installation's needs.
•
The kit panels are a special case and only allow a range of
1 to 2.
IMPORTANT NOTE:
Programming the installer´s parameters.
You can not configure the Cityline buttons panel alone,
since it does not have a keypad for entering the numeric
values. You must temporarily connect a keypad (ref. 7439)
to the last button module to change these parameters
(download the Direct Panels Programming Manual, cod.
97701) at www.fermax.com
).
Pag 17