Provo Craft Cuttlebug Manual Del Usuario página 4

Using Other Brand Dies
For Use With Non-Cuttlebug Thin Dies.
1. Position materials as shown, using
thin die adapter C instead of second
cutting pad B.
2. Move materials through Cuttlebug
machine by turning handle.
3. Remove all material from die;
discard unwanted pieces.
Fig 6
TIP
• For best results, experiment with scrap paper first.
All manuals and user guides at all-guides.com
Cutting pad
Paper
Cutting Die
Cutting pad
Spacer
Using Other Brand Dies
For Use With Steel Rule Dies.
1. Position materials as shown
using only the cutting pads B
excluding the spacer block A
from the assembly.
2. Move materials through Cuttlebug
machine by turning handle.
3. Remove all material from die;
discard unwanted pieces.
Fig 7
TIP
• For best results, experiment with scrap paper first.
Cutting pad
Steel Rule Die
Paper
Cutting pad