Replacing The Charcoal Filter; Light Replacement - Electrolux AEG DD6660-M Manual Del Usuario

EN
This fi lter cannot be washed or regenerated. It must be replaced when the C appears on the display
or at least once every 4 months. The fi lter saturation alarm has to be activated already before.
Activation of the alarm signal
• In Recirculation Version Hoods, the Filter Saturation Alarm must be activated on installation or
at a later date.
• Press and hold button E (Delay) for 5 seconds, until confi rmation appears on the display:
• C fl ashes twice – Activated Charcoal Filter saturation alarm ACTIVATED.
• C fl ashes once – Activated Charcoal Filter saturation alarm DEACTIVATED.

REPLACING THE CHARCOAL FILTER

Reset of the alarm signal
• Switch off the hood and the lighting.
• Press the D-key until the display is unlit.
Replacing of the fi lter
• Open the comfort panels pulling them downwards.
• Remove the metal grease fi lters.
• Remove the saturated charcoal fi lter by releasing the
fi xing hooks
• Fit the new fi lter and fasten it in its correct position.
• Put the metal grease fi lters in their seats.
• Close the comfort panels.

LIGHT REPLACEMENT

20 W halogen light.
• Remove the snap-on lamp cover by levering it from
under the metal ring, supporting it with one hand.
• Remove the halogen lamp from the lamp holder by
pulling gently.
• Replace the lamp with a new one of the same type,
making sure that you insert the two pins properly into
the housings on the lamp holder.
• Replace the snap-on lamp cover.
All manuals and user guides at all-guides.com
Charcoal fi lter (recycling version)
Lighting
11