ATH-Heinl ATH-W Manual De Instrucciones página 75

Remove the wheel from the balancing machine.
Measure the air pressure and remove the tyre
using a suitable tyre changer.
Fit the tyre on the wheel rim again and turn it
180°.
Fill the wheel with the same air pressure.
The wheel can then be mounted on the balancing
machine again. Pay attention to the marks on the
entry cover when doing so.
Start the balancing process using the STARTbutton
or by closing the wheel protector
The optimisation that has been calculated will then
appear on the display.
Turn the wheel when stretched until the display
opposite appears.
Mark the TYRE at the 12 o'clock position.
Turn the wheel when stretched until the display
opposite appears.
Mark the WHEEL RIM at the 12 o'clock position.
Remove the wheel from the balancing machine.
Measure the air pressure and remove the tyre
using a suitable tyre changing machine.
Fill the wheel with the same air pressure.
Start the balancing process using the STARTbutton
or by closing the wheel protector
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-10
- 14 -
/
/