ATH-Heinl ATH-W Manual De Instrucciones página 95

Press the START button again or close the wheel protector in order
to terminate the calibration process.
2.7.11.
1. Press the key combination STOP + OPT
2. The display shown opposite will appear
3. Position the gauge on the clamping cone
4. Press the ALU button
5. The display shows [CAL] – [200]
6. Now take the spacer and place it on the clamping cone
7. Next, position the gauge on the tip of the spacer
8. Press the ALU button
9. The display shows [CAL] – [End] and the correct calibration
10. If the display shows [CAL] – [0F], this means that the
calibration has been unsuccessful and must be repeated
When using the ALU S programme, it is recommend that the display threshold be set to 10 g.
Why:
- Because the machine records the dynamic and static imbalance, the operating characteristics of the
wheel change when the weights are affixed.
- Because the weights are positioned further towards the middle of the wheel rim, the weights
automatically achieve greater and more precise balancing results.
- Because the machine requires the balancing weights at one point and there are different adhesive
weight systems, this can cause a large weight distribution.
- The adhesive weights are not 100 % affixed in the correct location.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-10
Service calibration of the width gauge (optional)
- 34 -
/
+