Hilti NURON SJD 6-22 Manual Del Usuario página 16

5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Fitting the saw blade
1. Push the saw blade (teeth facing the cutting direction) into the blade holder until it engages.
2. Grip and pull the saw blade to check that it is held securely.
5.5 Fitting the guard
▶ Push the guard onto the power tool from the front until it clicks into place.
The guard can be fitted only when the base plate is in the normal position (0° cutting angle).
→ page 11
5.6 Fitting the dust removal adapter
1. Push the dust removal adapter on to the base plate horizontally from the rear until both catches engage
at the side.
2. Connect the vacuum cleaner hose to the dust removal adapter.
5.7 Fitting the anti-splinter insert
▶ Press the anti-splinter insert into the base plate from below.
The anti-splinter insert can be used only with the saw blades for which it is designed.
The anti-splinter insert can be used only when the base plate is in the normal position (0° cutting
angle). → page 11
5.8 Fall arrest 7
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only the Hilti tool tether #2261971.
▶ Use the loop to secure the tool tether to the product as shown in the illustration. Check that it holds
securely.
▶ Secure the carabiner to a load-bearing structure. Check that the carabiner holds securely.
Comply with the operating instructions of the Hilti tool tether.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Using a dust extractor
The dust extractor reduces dust emissions, increases working safety by providing better visibility of
the cutting line and reduces exposure to dust and wood chips at the workplace.
1. Fit the guard. → page 10
10 English
3
4
5
6
2264216
*2264216*