Makita DMR108N Manual De Instrucciones página 9

INSTALLATION AND POWER
SUPPLY
Installing or removing Slide battery
cartridge (Fig. 3 & 4)
● Always switch off the tool before installing or
removing of the battery cartridge.
● Hold the tool and the battery cartridge firmly when
installing or removing battery cartridge.
● To install the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way until
it locks in place with a little click.
● If you can see the red indicator on the upper side of
the button, it is not locked completely. Install it fully
until the red indicator cannot be seen. If not, it may
accidentally fall out of the tool, causing injury to you
or someone around you.
● Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being
inserted correctly.
● To remove the battery cartridge, withdraw it from
the tool while sliding the button on the front of the
cartridge or pressing the buttons on both sides of the
cartridge.
● Be careful not to pinch your fingers when opening or
closing the battery cover.
Installing or removing Cluster battery
cartridge (Fig. 5)
● To insert the battery cartridge, align the tongue on the
battery cartridge with the grove in the housing and
slip it into place.
● To remove the battery cartridge, take the battery out
of the terminal while pressing the buttons on the side
ofcartridge.
Return the battery compartment locker to the original
position.
Reduced power, distortion, "stuttering sound" or when
both low battery sign
on the display are all the signs that the main battery
pack needs to replace.
Note:
The battery pack can't be charged via the supplied AC
power adaptor.
When low battery sign
keeps on flashing is the time to replace the back up
batteries.
and "POWERFAIL" appear
appears and an "EMPTY"
Indicating the remaining battery
capacity (Fig. 6 & 7)
1. Indicator lamps
Only for battery cartridges with "B" at the end of the
model number
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Lighted
(For LXT battery cartridges only)
(For LXT battery cartridges only)
015658
Note:
● Depending on the conditions of use and the ambient
temperature, the indication may differ slightly from
the actual capacity.
● The first (far left) indicator lamp will brink when the
battery protection system works. (For LXT battery
cartridges only)
Using the soft bended rod antenna
(Fig. 9)
Straight up the soft bended rod antenna as shown in the
figure.
Using Supplied AC power adaptor
(Fig. 10)
Remove the rubber protector and insert the adaptor plug
into the DC socket on the left side of the radio. Plug the
adaptor into a standard mains socket outlet. Whenever
the adaptor is used, the battery pack is automatically
disconnected. The AC adaptor should be disconnected
from the main supply when not in use.
Note:
When your radio has any interference in AM band by its
adaptor, please move your radio away from its AC
adaptor over 30cm.
9 ENGLISH
2. Check button
Off Blinking
75% to 100%
malfunctioned
Remaining
capacity
50% to 75%
25% to 50%
0% to 25%
Charge the
battery
The battery
may have