Glass Cooktop - Haier QSS740 Manual Del Usuario

CARE AND CLEANING

GLASS COOKTOP

Normal Daily Use Cleaning
ONLY use ceramic cookt op cleaner on t he glass cookt op.
Ot her creams may not be as effect ive.
To maint ain and prot ect t he surface of your glass cookt op,
follow t hese st eps:
1. Before using t he cookt op for t he first t ime, clean it wit h
ceramic cookt op cleaner. This helps prot ect t he t op and
makes cleanup easier.
2. Before using t he cookt op for
t he first t ime, clean it wit h
ceramic cookt op cleaner. This
helps prot ect t he t op and makes
cleanup easier.
3. Shake t he cleaning cream well.
Apply a few drops of ceramic
cookt op cleaner direct ly t o t he
cookt op.
4. Use a paper t owel or non-
scrat ch cleaning pad for ceramic
cookt ops t o clean t he ent ire
cookt op surface.
5. Use a dry clot h or paper t owel t o
remove all cleaning residue. No
need t o rinse.
NOTE: It is very import ant t hat you
DO NOT heat t he cookt op unt il it has
been cleaned t horoughly.
Burned- On Residue
NOTE: DAMAGE t o your glass surface may occur if you use
scrub pads ot her t han t hose recommended.
1. Allow t he cookt op t o cool.
2. Spread a few drops of ceramic cookt op cleaner on t he
ent ire burned residue area.
3. Using a cleaning pad for ceramic cookt ops, rub t he
residue area, applying pressure as needed.
4. If any residue remains, repeat t he st eps list ed above as
needed.
5. For addit ional prot ect ion, aft er all residue has been
removed, polish t he ent ire surface wit h ceramic cookt op
cleaner and a paper t owel.
Use a non- scrat ch cleaning pad for ceramic cookt ops.
18
Heavy, Burned- On Residue
1.
2.
3.
4.
Ceramic
Cooktop
Cleaner
Clean your cookt op aft er
each spill. Use ceramic
cookt op cleaner.
Met al Marks and Scrat ches
1.
For cleaning videos and
inst ruct ions, scan t he QR
code wit h your device.
2.
NOTE: Carefully check t he bot t om of pans for roughness
t hat would scrat ch t he cookt op.
3.
Allow t he cookt op t o cool.
Use a single- edge razor blade scraper at approximat ely a
45° angle against t he glass surface and scrape t he soil. It
will be necessary t o apply pressure t o t he razor scraper
in order t o remove t he residue.
Aft er scraping wit h t he razor scraper, spread a few drops
of ceramic cookt op cleaner on t he ent ire burned residue
area. Use a non- scrat ch cleaning pad t o remove any
remaining residue.
For addit ional prot ect ion, aft er all residue has been
removed, polish t he ent ire surface wit h ceramic cookt op
cleaner and a paper t owel.
The ceramic cookt op scraper and all recommended supplies
are available t hrough our Part s Cent er. See t he Accessories and
Consumer Support sect ions at t he end of t his manual.
NOTE: Do not use a dull or nicked blade.
Be careful not t o slide pot s and pans across your cookt op.
It will leave met al markings on t he cookt op surface.
These marks are removable using t he ceramic cookt op
cleaner wit h a non- scrat ch cleaning pad for ceramic
cookt ops.
If pot s wit h a t hin overlay of aluminum or copper
are allowed t o boil dry, t he overlay may leave black
discolorat ion on t he cookt op.
This should be removed immediat ely before heat ing
again or t he discolorat ion may be permanent .
Be careful not t o place aluminum baking sheet s or
aluminum frozen ent rée cont ainers on a hot cookt op
surface. It will leave shinny dot s or markings on t he
cookt op surface. These markings are permanent and
cannot be cleaned off.
49- 2001025 Rev. 0