Care And Maintenance - Lavor METIS Manual De Instrucciones

> STEAM AND WATER OUTPUT ADJUSTMENT
(see fig. B)
Adjust the steam and water output by using the
two knobs situated on the the left hand side of
the machine ⑦.
wet steam ;
WARNING:
- For any subsequent adjustment, setting or
replacement of parts not foreseen in this
manual, please contact qualified personnel at
the manufacturer or resale outlet.
- Before carrying out any replacement, ensure
that the main switch is in the (0) OFF position.
> START-UP
Description of the start sequence
After carrying out all the connections and preven-
tative inspections described in the previous chap-
ters, start the machine according to the following
instructions:
- Before starting the generator, fill the tanks with
DIESEL up to the set level.
1) Press the main switch situated on the control
panel to the ( I ) ON ⑨
2) Press the BOILER ON button situated on the
control panel to ( I ) ⑩.
3) Keep the trigger pressed
- If the display show H2O , it means that there is
no water in the tank. Fill the tank (see "Filling the
tanks with water")
> MACHINE STOP AT END OF WORK
At the end of the work shift, stop the machine in the
following way:
1) Press boiler switch button to (0) OFF ⑩
2) Press main switch to (0) OFF ⑨.
3) Unplug the machine from the electrical power
supply.
Boiler drain
Follow the instructions below:
- A few minutes before the end of the work shift,
dry steam ;
turn off the boiler by pressing the BOILER START
luminous green push-button, continuing to use
the steam gun until the pressure gauge indicates
a value of 0-1 bar;
(see fig. E)
- Carefully open the boiler drain cock ⑯ , situated
on the machine and drain all the water from the
boiler into a suitable container;
WARNING: Danger from hot steam.
WARNING:
V15 While the machine is functioning, it
is strictly forbidden to remove safety devices
set by the Manufacturer for the purpose of
protecting the operator against incidents.
- Only skilled and qualified operators must use
the machine.
- Avoid aiming the steam lance towards
personnel or delicate objects such as plastic,
crystal or other materials which may melt or
deteriorate with contact to steam at 180°C.
- Never leave the machine unattended.
- Always remove the power supply from the
machine before filling the tanks.

CARE AND MAINTENANCE

SCHEDULED MAINTENANCE PLAN
Visit website and download the scheduled
maintenance plan.
IMPORTANT: Before doing any work
on the cleaner, discharge the pressure
and disconnect the electricity and water
supplies.
SEE ROUTINE MAINTENANCE TABLE
WARNING
Before any maintenance or replacement activity,
remember to:
- stop the machine (MAIN SWITCH turned to
OFF)
- unplug it.
K1 Maintenance, replacement or servicing
activities described in this handbook must be
entrusted only to skilled operators familiar
19
EN