Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Powering the Recorder
Battery Installation
1. To remove the battery compartment cover, press down on the tab
(as indicated below) and lift the cover off the back of the device.
2. Insert 4 R14--or C Cell--size batteries (not included) into the battery
compartment. Be sure the (+) and (-) ends of the batteries are
installed as shown on the battery diagram.
3. Put the battery cover back on the device.
NOTE: If the recorder begins to sound distorted or the tape reels turn
very slowly or not at all, try replacing the batteries or using another
cassette before seeking service.
IMPORTANT: Be sure to remove the batteries when storing the device
for more than a few weeks at a time. Leaking batteries can damage the
recorder. When discarding batteries, be sure to dispose of them in the
proper manner, according to provincial/state and local regulations.
Always push STOP before storing. This will relieve pressure on certain
parts in the recorder that might bend after long periods of time.
AC Power Converter
The AC Power Converter plugs into the 6-V DC PWR JACK on
the recorder (which automatically replaces battery power), and
plugs into 230-volt AC household power.
2
Publicidad
Tabla de contenido
