Coby CVR-22 Manual De Instrucciones página 6

Standing Microphone Recording
To record with the standing microphone, plug the microphone into the
MICROPHONE jack and follow the built-in microphone recording
instructions. When the standing microphone is in use, the built-in
microphone is automatically disconnected. Remove the standing
microphone to switch back to built-in microphone recording.
Erasing A Tape
To erase a tape simply record over the unwanted recording.
Rewind
To run the tape back to the beginning of your recording, press
REWIND. Then press STOP after you have rewound to the desired
point on the tape.
Fast Forward (F-FWD)
Press F-FWD to quickly skip over portions of the tape.
Press STOP after you have advanced to the desired point on the tape.
Pause
Your recorder is equipped with a PAUSE button which will stop the
PLAY & RECORD operations. Press again to release PAUSE to
continue your chosen operation.
Care & Maintenance
Prevent Accidental Erasing
Whenever you make a recording, any
previous recording on the tape is
automatically erased. When you have
a recording you want to keep
permanently, snap out the rear left tab
of the side you want to save as shown
in the illustration below.
5