Sovelor HPV MAX Manual página 9

en
The appliance stops when an anomaly occurs.
The reset button turns on with a steady red light
it
(PIC. 7), it means the heater needs to be reset.
de
To reset the heater, press the reset button all
the way down (PIC. 8). Identify and remove
es
the cause that stopped the appliance (for
instance, obstruction of air intake and/or outlet,
fr
total block of the fan, etc.). Please contact an
nl
appointed service center for assistance in case
it is impossible to solve the problem.
pt
da
Set the "I/0" button to "0" (A PIC. 5). Flames
extinguish and the fan keeps on working until
the combustion chamber has fully cooled down.
no
Do not pull the plug out until the cooling
cycle has totally ended.
sv
pl
8. CLEANING THE FILTERS
ru
cs
hu
8.1.1. Remove tank (A) cap.
sl
8.1.2.
tr
8.1.3.
without damaging it.
hr
8.1.4.
8.1.5. Close cap (A).
lt
lv
DEPENDING ON THE MODEL:
et
8.2.1. Remove the cup (A).
8.2.2.
ro
Keep gaskets for later use.
sk 8.2.3.
without damaging it.
bg
8.2.4.
8.2.5. Put the glass (A) back on and
uk
reassemble the gaskets correctly.
bs
el
See the preventive maintenance schedule.
zh
during transport.
PROCEDURE:
9.1. Empty the fuel by removing the drain
cap at the bottom of the tank (PIC. 12).
Dispose the fuel in an appropriate container
in accordance with the current safety
regulations.
9.2. To remove any residual remaining, pour
clean fuel and rinse the tank again.
9.3. Close the drain cap and the tank cap.
9.4. In order to keep the heater in the best
possible conditions, we recommend placing
it in a dry and safe place.
THERMOSTAT
In models with a thermostat connection,
remove the cap connected to the appliance
and connect the room thermostat (optional)
(SEE PIC. 13-14).