Putting Into Operation; Filling With Water - Fagor TK-2005 Manual De Instrucciones

All manuals and user guides at all-guides.com
interior 31/5/05 19:12
and maintenance! Disconnect the plug
from the mains!
• Do not use the cable to pull on the plug
or pull the plug out of the socket when
hands are wet!
• Warning! Danger of electric shock or
short-circuit! Protect the appliance and
the power base from dampness. Never
put them into the dishwasher! Never
immerse them in water!
• Observe the instructions for de-scaling!
3. USE IN ACCORDANCE WITH
PURPOSE
The appliance may only be used to heat
and boil water. Never put milk, soup,
coffee or tea, etc., into the kettle.
No liability is accepted for any damage
resulting from use for other purposes, faulty
operation or amateur repairs. Guarantee
services are also excluded in such cases.
The appliance is not intended for
catering purposes!
Operating the appliance for the first time
FIG. 1
Before using the kettle for the first time, fill it
up to the maximum level and boil at least
two lots of water.
Rinse the kettle out with cold water each
time between boiling up these two lots of
water.
Method:
• Adjust the required length of cable onthe
power base "g".
Wind any cable not required onto the
cable winder. Guide the cable through
one of the three recesses (1).
• Connect the power base "g" according to
instructions (observe the safety
instructions).
• Put the appliance into operation
(see"Putting into operation").
Página 7

4. PUTTING INTO OPERATION

FIG. 2 – 8

Filling with water

• To open the lid, push the lid opener
"b"forwards, the lid will snap up (2).
Note
The lid is opened with a spring mechanism.
Ensure that the lid does not hit any part of
the body.
• Open the lid and fill the kettle while the
lid is open (3).
• Check the filling level on the water level
gauge "d". Note the maximum filling level
(4)!
Note
If the kettle was accidentally started empty,
the safety cut-out will automatically switch it
off. In this case you should remove the
kettle from the power base and allow it to
cool down for a few minutes. Make sure
that the kettle has been filled with an
adequate amount of water before using it
again.
Switching on the kettle
• Close the lid. The safety locking lid must
lock into place (5).
Connect the power base to the mains and
position the kettle on the power base (6).
Note
If the lid is not properly closed, the kettle will
not shut off automatically.
• Switch on the kettle at the ON/OFF
switch "f" - the red heating control lamp
"e" lights up (7).
Note
The ON/OFF switch only operates when the
kettle is located on the power base.
Warning! Risk of scalding!
Never open or remove the lid during
operation.
Switching off the kettle
• The kettle switches off automatically
when the water boils - the red heating
control lamp "e" goes off (8). However,
you can also switch the kettle off using
the ON/OFF switch "f" at all times.
Note
The kettle also switches off automatically
when it is removed from the power base.
8