XII REMOVING THE SEAT COVER The seat cover can be removed for washing. First, remove the canopy by unlocking the
hooks on both sides, disconnect the clips connecting the canopy to the cover and remove the canopy (Fig.Y). Then remove
the belt on the underside of the seat, remove the Velcro on the footrest and then the four Velcro on the underside of the
seat (Fig.Z). Remove the seat (Fig.A'). Remove the insert inside of the cover by first putting all shoulder and crotch straps
through the holes in the insert and cover (Fig.B').
XII SUSPENSION ADJUSTMENT The suspension can be adjusted in two levels (soft "I" and hard "II") depending on the child's
weight and type of surface. To adjust the suspension, move the lever on the rear axle to the desired position, as shown in
Figure C'.
XIV CAR SEAT ASSEMBLY ON BUGGY FRAME The supplied adapters are compatible with the following car seats:
Kinderkraft®, Kiddy®, Maxi Cosi®, Cybex®, BeSafe®, Nuna® and they are suitable for the following models: Kinderkraft MINK,
Kiddy Evoluna I-Size 2, Evolution Pro 2, Cybex Aton, Aton 2, Aton Q, Maxi Cosi Mico, Mico AP, Mico NXT, Mico Max 30, Citi,
Cabrio, CabrioFix, BeSafe iZi Go, iZi Go Modular, Nuna Pipa. Place the adapters on both side of the seat . When installing the
car seat on the buggy frame, stick them in the designed slots, one on each side of the buggy until you hear a distinctive clock
(Fig.D'). Removing the seat press the buttons on both sides and pull up. The car seat must always be fitted in such a way
that the child should face the carer.
XV CARE AND MAINTENANCE The buyer is responsible for proper installation of all functional elements as well as for
carrying out all required maintenance and adjustments in order to keep the buggy in good technical condition. The buggy
must be periodically checked for potential problems. Significant measures to be applied to ensure the child's safety and
prevent shortening of the product life have been presented below:
• Check the strength and safety of all rivets and connections.
• Check all wheel locking equipment and tyres. If necessary, replace or repair.
• Check if all safety devices work properly, particularly the main and additional fasteners that should move freely at any
time. Please stop using the buggy if there are doubts as to its proper use or a suspicion of any danger. Use only the spare
parts supplied or recommended by the manufacturer. If the wheels squeak, apply a thin layer of silicone. Do not use oil or
grease based products as they attract dirt, which makes it difficult for the wheels to move.
XVI CLEANING If the elements of the buggy chassis have been exposed to saltwater, rinse with tap water as soon as possible.
Wash at max. 30°C, gentle process.
Do not bleach
Do not dry in a tumble dryer
Do not fold or store the product when it is wet and never store it in wet conditions as it can lead to mould growth.
Seat cover, Mosquito net, Foot cover, Foot cover for pram body, Sun cover, Pram body cover, Mattress cover: Wash at
max. 30°C, gentle process, Do not bleach, Do not dry in a tumble dryer, Do not iron, Do not dry clean.
Canopy, Canopy for pram body, Rain cover, Basket: Do not wash. Clean the product gently with a damp cloth and a mild
detergent, Do not bleach, Do not dry in a tumble dryer, Do not iron, Do not dry clean.
XVII Warranty
1. All Kinderkraft products are covered by a 24-month warranty. The warranty period begins on the date of releasing the
product to the Buyer.
2. The warranty is valid for products sold in the following countries: France, Spain, Germany, Poland, United Kingdom, Italy.
3. In countries not listed above warranty terms and conditions are determined by the Seller.
4. It is possible to extend the warranty period to 120 months (10 years). Full text of the terms and conditions and warranty
extension registration form are available at
5. The warranty is valid only in the country where the purchase was made.
6. Complaints should be submitted by completing the form available at
7. The warranty shall not cover:
a. claims arising from product specifications, as long as they comply with those specified by the manufacturer in the
instruction manual or other documents of a legislative nature;
b. product damage caused by improper maintenance or use of inadequate chemicals;
c. colour change (discolouration) when the product has been exposed to direct sunlight against the instructions provided
in the instruction manual;
d. tear, wear, crack of fabric/plastic that is the fault of the Customer;
e. reduction in the quality of the product and consumables due to normal wear and tear;
f. products which have not been used according to specifications;
8. The warranty period for accessories attached to the device is 6 months from the date of sale, with the exception of
mechanical damage.
WWW.KINDERKRAFT.COM
33
Do not wash. Clean the product gently with a
damp cloth and a mild detergent.
Do not iron
Do not dry clean
WWW.RMA.KINDERKRAFT.COM