Protool RGP 3 Manual Del Usuario página 7

Application Table
The information given here are recommendations.
The optimum combination is best determined with
practical trials.
Grinding Plate Application
a b c d
Grinding of overhangs and unevenness
•
— — —
on poured flooring
• • Removal of unevenness and form transi-
— —
tions on exposed concrete
Grinding of soiled and weathered con-
•
— — —
crete surfaces
• — — — Rounding the edges of concrete parts
• • Grinding of cement facing
— —
Roughing or grinding off of plaster
— — • •
Removing of oil paint from plastered sur-
• •
— —
faces
• • Grinding off of bituminous and concrete
— —
paints
— —
• • Removing of coatings and elastic paints
(e. g. cellar stairs, furnace rooms, balco-
nies, etc.)
• Removing of epoxy resin from cement
— — —
and poured flooring surfaces
Removing of paint and rust from metal
•
— — —
parts
Grinding and roughing of flat surfaces on
•
— — —
tiles
• Grinding off of tile adhesive and mineral
•
— —
adhesive residues
a - Grinding plate with diamond
coating
b - Grinding plate with hard metal
content FINE
c - Grinding plate with hard metal
content ROUGH
d - Grinding plate with silicium-
carbide content
Storage
The unit should be stored in a dry place where it is
protected against freezing.
Environmental Protection
Do not open worn out machines and return to the
collection facilities provided for recycling.
All manuals and user guides at all-guides.com
Maintenance
Service
See enclosed sheet.
Guarantee
We guarantee PROTOOL appliances in accordance
with statutory/country-specific regulations (proof
of purchase by invoice or delivery note).
Damage attributable to normal wear and tear, over-
load or improper handling will be excluded from the
guarantee.
In case of compliant please send the machine,
undismantled, to your dealer or the Service Centre
for electric power tools.
We declare under our sole responsibility that this
product is in conformity with the following stand-
ards or standardization documents: EN 50 144,
EN 55 014, EN 60 555, HD 400 according to the
provisions of the regulations
2004/108
Stanislav Jakeš
Research and development
Protool GmbH
Wertstr. 20
D-73240 Wendlingen
29. 12. 2009
The ventilation slots (3) on the motor casing
should be cleaned out from time to time.
Maintenance and repair work that requires the
opening of the machine may be performed only
by an authorised customer service workshop.
When the carbon brushes are worn out, the
machine switches itself off. The machine must
then be sent to customer service for maintenance
(see enclosed sheet).
Declaration of Conformity
/EC, 2006/42/EC.
Subject to change
9