Before Starting The Equipment; Dust Extraction; Replacing The Power Cable; Cleaning And Maintenance - Robust RB-BS 850/1 Manual De Instrucciones Original

Anleitung_RB_BS_850_1_SPK7__ 02.07.12 09:30 Seite 14
GB
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.

5.1 Dust extraction

5.1.1 Installing the dust bag (Figure 3/Item 12)
Slide the dust bag (12) on to the connection for the
dust extractor (6). Follow the instructions above in
reverse order to remove the dust bag.
The dust is extracted straight from the
sanding/grinding belt into the dust bag.
Important. For health safety reasons it is
imperative that you use a dust bag.
5.2 Changing the sanding / grinding belt
(Fig. 4-5/Item 11)
Pull the clamping lever (10) to the outside to
n
relieve the tension in the sanding/grinding belt.
Pull the used sanding/grinding belt off the drive
n
rollers.
Slide the new sanding/grinding belt on to the
n
drive rollers.
Ensure that the direction of the sanding/grinding
n
belt (arrows on the inside of the sanding/grinding
belt) is identical to the direction of the belt
sander/grinder (arrow over the rear drive roller).
Press the clamping lever (10) to the rear to
n
tension the sanding/grinding belt.
5.3 Adjusting the position of the belt
(Fig. 6/Item 2)
Hold the belt sander/grinder with the
n
sanding/grinding plate at the top.
Switch on the belt sander/grinder.
n
By turning the setting screw (2) the belt position
n
should be set so that the sanding/grinding belt is
at the center of the two drive rollers.
14
All manuals and user guides at all-guides.com
6. Starting up
6.1 Switching ON/OFF (Fig. 7)
To switch on:
Press the ON/OFF switch (5).
Continuous operation:
Secure the switch (5) with the locking button (4).
To switch off:
Press the ON/OFF switch (5) briefly.
The machine can be operated on a temporary or
permanent setting.
6.2 Setting the belt speed (Fig. 8/Item 3)
You can select the belt speed by turning the setting
knob (3).
PLUS direction:
Increase belt speed
MINUS direction:
Reduce belt speed
6.3 Instructions for use
Important. Never hold the workpiece you wish to
sand/grind in your hands. Secure the workpiece on a
sturdy surface or using a vise.
Allow the belt sander/grinder to start before you
n
place it on the workpiece.
Do not switch off the belt sander/grinder as long
n
as the sanding/grinding belt is in contact with the
workpiece.
Always hold the belt sander/grinder with both
n
hands whilst it is in use.
Always sand wood in the direction of the grain.
n

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.

8. Cleaning and maintenance

Always pull out the mains power plug before starting
any cleaning work.