Browser
Microsoft Internet
Explorer
Mozilla Firefox
Netscape Navigator
Apple Safari
Google Chrome
Table 4. Browser Compatibility
To access the device with the WebUI:
1. Connect your workstation on the port labeled
LAN (1-4), which is pre-allocated to the LAN.
2. Ensure your workstation is configured with a
static IP address in the 192.168.10.0/24
subnet.
Note: Disable pop-up blocking software or
add the management IP address
http://192.168.10.1 to your pop-up blocker's
allow list.
3. Launch your browser; enter the IP address
for the LAN interface. (The factory default IP
address is http://192.168.10.1), then press Enter.
Figure 6. Browser Address
4. Log on the Unified Services Router Web
Interface The default log on information is:
Username: admin
Password: admin
Figure 7. Authentication Message
Version
Using a Console Connection
6.0 or higher
(RJ45-to-DB9 DCE)
The Unified Services Router provides an serial
port that enables a connection to a computer or
3.5 or higher
terminal for monitoring and configuring the device.
This port is a RJ-45 connector, implemented as a
data communication terminal equipment (DCE)
9.0 or higher
connection.
4.0 and later
To use the console port connection, you need the
following equipment:
3.0 and later
1. A terminal or a computer with both a serial
port and the ability to emulate a terminal.
2. A
connector. (Already included in packing list)
3. If your Laptop or PC doesn't have RS-232
connector, a converter is required.
Note: DSR-500/1000 does not come with RS-232
converter and these must be purchased separately.
To establish a console connection:
1. Plug the RJ-45 connector of the supplied
RJ45-to-DB9 cable directly to the console
port
2. Connect the other end of the cable to a terminal
or to the serial connector of a computer
running terminal emulation software. Set the
terminal emulation software as following:
3. When you have correctly set up the terminal,
having previously followed the instructions
in section, "Connecting Power and Turn the
Device On/Off" then switch on your device.
The boot sequence appears in the terminal.
4. Once the boot sequence completes, the
command prompt is displayed, the device is
ready to be configured.
RJ45-to-DB9
RS-232
on
the
Unified
Baud rate: 115200
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
D-Link Unified Services Router 5
with
female
Services
Router.