Descargar Imprimir esta página

ORIUM 11150 Manual Del Usuario página 10

Reloj calendario radiocontrolado agenda

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Setting alarm 2
Press the "MODE" button twice: the hour for alarm 2 and
(7am by default)
Hold the "MODE" button down for 3 seconds:
The hour for alarm 2 flashes Use the "+" or "-" buttons to set the
-
required hour for alarm 2. Press "MODE" to confirm your setting
The minutes flash Use the "+" or "-" buttons to set the minutes for
-
alarm 2. Press "MODE" to confirm your setting
Activation / deactivation of alarms:
5.
In normal display mode, press the "ALARM" button once, the
displayed next to the minutes. Alarm 1 is activated.
Press the "ALARM" button again,
2 is activated.
Press the "ALARM" button a third time,
the minutes. Alarms 1 and 2 have been activated.
Press the "ALARM" button a 4th time,
have been deactivated.
The alarm will go off for 2 minutes if you do not stop it by pressing one of the
mode/
/+/- buttons. The alarm will go off automatically every 24 hours if you
do not deactivate it.
Crescendo alarm: the alarm will gradually become louder during the 2
minutes.
Snooze function (repeater alarm):
When the alarm goes off, you can trigger the repeat function (which will go off
5 minutes later) by pressing the "SNOOZE" button on the rear of the clock:
or
flashes.
The Snooze (repeater) function can be stopped by pressing on any other
button (mode/
/+/-).
Dispay of the temperature in °C or °F:
6.
The temperature is either displayed in degrees centigrade (°C) or Fahrenheit
(°F). Briefly press the "-" button to toggle between the units.
There is a manufacturer's tolerance of ± 1°C
Maintenance:
7.
You can clean your clock with a soft or microfiber cloth to avoid micro-
scratches on the face. Do not use solvents or any other solution that might
damage the product.
Replacing the batteries:
8.
When the digital display becomes faded you need to change the batteries.
Open the battery compartment at the back of the clock by gently pulling the
lid. Remove the used batteries, then install 2 new LR6 batteries in the
.
is displayed next to the minutes. Alarm
and
and
are displayed
icon is
icons are displayed next to
are removed. The 2 alarms

Publicidad

loading

Productos relacionados para ORIUM 11150

Este manual también es adecuado para:

11152