For Your Information - ORIUM 11150 Manual Del Usuario

Receving the radio-control signal:
2.
When the batteries are inserted, all the symbols on the screen are briefly lit,
together with an audible signal and the device will receive the radio-control
signal for 7 minutes (the aerial next to the minutes display will flash).
Once the signal has been captured, the
displayed: your clock is set to the exact time and date.
If this automatic setting procedure does not function with no signal being
received, press the
To ensure good reception, keep the clock away from all electromagnetic
sources (TV, computer, microwave, etc.). Radio reception is weaker in rooms
with concrete walls (in cellars, for example) or in metal-frame buildings. In
these cases, place the clock near the window.
If a signal is not received within 7 minutes, the search for a signal will stop (the
radio aerial symbol will disappear from the screen).
In the event of poor reception, your clock will automatically trigger another
search at 1am (the time at which there is the least interference). At 1am, the
clock automatically synchronises with the DCF signal to correct any variance
with the exact time. If synchronisation fails (the radio aerial symbol will
disappear from the screen), the system will automatically run another
synchronisation session on the next hour. This procedure is repeated
automatically every hour until 5 am.
Note: when the clock is in signal receiving mode, none of the buttons will
function. You can stop the search for a radio signal manually during the radio-
controlled signal receiving procedure by pressing the
stop flashing. You can go ahead with other settings, the buttons will now
function.

For your information:

When the radio aerial symbol flashes, this indicates that DCF signal
reception has started.
Permanent display of the radio aerial
has been successfully received.
The clock can take 24 hours before it captures the signal and is set to the right
time.
Manual setting of the language, time and calendar:
3.
In the event of poor reception of the signal, you can set the calendar and time
manually.
Press the "MODE" button for more than 3 seconds:
The language flashes: select the required language using the "+" or "-"
-
buttons: GERMAN / FRENCH / ENGLISH / POLISH / SWEDISH /
DUTCH / SPANISH / ITALIAN. Press the "MODE" button again to
validate the setting.
button to trigger a manual search for the DCF signal.
symbol will continue to be
button. The aerial will
symbol means that the DCF signal