cable matters 202070 Manual Del Usuario página 7

3.2 Remote Installation
Remove the insulating tab from the end of the battery and
check that the battery is installed correctly
Troubleshooting tips:
Replace the battery
•
Make sure the Switch is turned on and remote control
•
is not turned off on the Switch
3.3 Connection Instructions
1. Power off all source equipment
2. Make sure the switch is "OFF" before connecting any device
3. Optional: Connect the included USB-C AC adapter to the USB-C
port and a wall outlet
4. Connect the DisplayPort and micro-B cables from the switch to
each computer. Connect DP 1 and micro-B 1 to computer #1, and
connect DP 2 and micro-B 2 to computer #2
5. Connect the switch box to up to 3 USB peripherals through the
USB-A ports
6. Connect a DisplayPort monitor to the front panel DisplayPort port
www.cablematters.com
5
USB 3.0 KVM Switch for 2 Computers