CONTENTS
SERPENT'S SPIRAL. . . . . . . 4
&
SERPENT'S TOWER . . . . . . 74
Building Idea . . . . . . . . . . . . . . . . .
Translations:
2
All manuals and user guides at all-guides.com
IMPORTANT STUFF
FOR PARENTS & KIDS
Keep these instructions in a handy
42
location. They contain important
73
safety information.
Read all warnings and instructions
before you start to build and
operate the model.
117
WARNING: CHOKING HAZARD -
Small parts. Not for Children under 3 years.
CAUTION: Keep hands, face, hair and
clothing away from all moving parts.
CAUTION: Be careful not to tip the model
over. Model should be placed on a flat and
hard surface.
•
Share the K'NEX experience with your child
and make building with K'NEX a family fun
adventure.
•
Take your time to enjoy the building process.
Don't rush!
•
While you're building make sure you face your
model in the same direction as the pictures
show in the instructions.
•
Be sure to install batteries into the motor
before you start building your motorized
models.
•
Product and colors may vary.
Caution: To Avoid Battery Leakage
•
Be sure to insert the batteries correctly and always
follow the toy and battery manufacturers' instructions.
•
Do not mix old and new batteries or alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Only batteries of the same or equivalent type
recommended should be used.
•
Always remove weak or dead batteries from the product;
do not short-circuit supply terminals.
•
Insert batteries with correct polarity (+/-) as shown.
Important Tips
•
Alkaline batteries AA (LR6) are recommended.
•
Rechargeable batteries are not recommended.
•
Remove rechargeable batteries from toy before charging;
they must be charged only under adult supervision.
•
Non-rechargeable batteries must not be recharged.
•
Keep components free of dust; do not immerse or use
in water.
•
Do not dispose of batteries in a fire; they could leak
or explode and cause injury.
•
Remove all batteries if the toy will not be used for a long
period of time.
•
Do not put Rods smaller than 2 inches in any openings
of the motor; they will damage the motor, and cannot be
removed.
How to Insert and Remove Batteries
•
Use a small Phillips
head screwdriver
to loosen the
screw. Insert 2
fresh AA batteries
(LR6) into the
compartment with
the correct polarity
(+/-) as shown
here.
Find more Building Ideas at
BATTERY INFORMATION
+
-