Motor Safety Filter Changing - KENMORE ELITE BC7005 Manual De Uso Y Cuidado

WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner from
electrical outlet. Do not operate the
vacuum cleaner without the motor safety
filter. Be sure the filter is dry and properly
installed to prevent motor failure and/or
electrical shock.
MOTOR SAFETY FILTER
ELECTROSTATIC
This filter must be replaced when dirty. It
should be replaced regularly depending on
use conditions. The filter CANNOT be
washed as it will lose its dust trapping
ability.
NOTE: See REPLACEMENT PARTS for part
number detail (page 5).
1. Remove the bag as outlined in the DUST
BAG CHANGING (page 19) section.

MOTOR SAFETY FILTER CHANGING

2. Lift the rubber retainer and pull out motor
safety filter as shown.
Rubber
Retainer
3. Replace the filter, white side out, facing
the dust bag, by sliding it back into place
under the ribs in the bag cavity. Tuck filter
in so that it fits completely under the rubber
retainer.
4. Replace the bag as outlined in the DUST
BAG CHANGING (page 19) section.
- 20 -