Sony MDR-SA5000 Manual De Instrucciones

Stereo
Headphones
Operating Instructions
Manual de instrucciones
MDR-SA5000
© 2005 Sony Corporation
English
WARNING
To prevent fire or shock hazard,
do not expose the unit to rain or
moisture.
To avoid electrical shock, do
not open the cabinet. Refer
servicing to qualified personnel
only.
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
2-587-857-11(1)
Printed in Japan
Features
• 110 kHz reproduction
The newly-developed
Nanocomposite HD (High Definition)
Driver Unit reproduces ultra-wideband
from low to 110 kHz by only one unit.
• Super lightweight with magnesium frame
structure
• Porous housing
By adopting a porous housing with a
cellulose material finished to give
appropriate air-flow resistance,
unpleasant resonance is minimized and
eliminated some weights of the unit.
• Natural leather earpads
Adoption of natural leather for earpads
make pleasant feel for your listening
comfort.
• Widen headpad
By expansion of the width of the
headpad to ensure wider contact area to
diffuse the pressure on the head, and
adoption of high elastic mesh fabric,
gives a natural wearing comfort with light
weight and good ventilation.
3
• 360 kJ/m high power neodymium
magnets are used to reproduce clear mid-
range sounds and wealthy low range
sounds.
• 6N-OFC texture cord
6N-OFC, Oxygen Free Copper with super
high-purity (99.9999%), is used for the
core of the cord.
• Supplied with headphones stand for the
convenience of storing.
How to use
Wear the headphone marked "RIGHT" on
your right ear, and the one marked "LEFT"
on your left ear.
LEFT
The slider can be set to one of 11 positions.
Adjust to the desired position.
When installing on the stand
Shorten the slider to the lowest position to
prevent deformation of the earpads.
Specifications
Type
Open air, dynamic
Driver units
50 mm, (CCAW adopted), dome type
Power handling capacity
1,500 mW (IEC*)
Impedance
70 Ω at 1 kHz
Sensitivity
102 dB/mW
Frequency response
5 Hz – 110 kHz
Cord
3.5 m (11.5 ft), 6-N OFC litz cord
Plug
Gold-plated stereo phone plug
Mass
Approx. 260 g (9.2 oz) without cord
Supplied accessories
Stand (1), Operating Instructions (1),
Warranty (1), Product Information (1)
* IEC = International Electrotechnical
Commission
Design and specifications are subject to
change without notice.
Precautions
Preventing hearing damage
Avoid using headphones with the volume
turned up for an extended period of time.
Doing so can damage your hearing. It is
advisable to keep the volume at a moderate
level at all times.
Road safety
Never use headphones while driving or
cycling, etc. It can be dangerous to turn up
the volume too much even while walking.
Doing so may hinder your hearing and can
be hazardous especially at level crossings or
pedestrian crossings.
Caring for others
Remember not to disturb people around you
with the sound leaking from your
headphones. Keep the volume level
moderate even in noisy places so that you
will be able to hear other people when they
talk to you.
Notes on usage
• Do not put weight or pressure on the
headphones as it may cause the
headphones to deform during long
storage.
• Do not subject the headphones to strong
shock by dropping or banging.
• Handle the unit part with care.
• Do not leave the headphones in a location
subject to direct sunlight, heat or
moisture.
• Leaving the plug dirty may cause sound
distortion.
• Clean the headphones with a soft dry
cloth.
• Do not use strong solvents (benzene,
alcohol, etc) when cleaning the
headphones. Doing so may cause
discoloration, deformation, deterioration
and other damages.
• Newly developed low-repulsion urethane
earpads work best to your wearing
comfort at temperatures of about 10 °C or
higher (room temperatures). The earpads
may feel rather hard in the low
temperature settings. This does not
indicate deterioration of the earpads.
Their original softness will be restored at
room temperature.
• Since natural leather is used in the
earpads, natural blemishing or scuffing
may be seen, which we consider a valued
feature. This does not affect the function
of the headphones.
• Since the earpads are made from natural
material, the color may face. Also, the
pattern and color of the leather may vary.
• The earpads may deteriorate due to
long-term storage or use.
• For changing the earpads or repairing the
headphones, please consult a Sony dealer.
• The CE mark on the unit is valid only for
products marketed in the European
Union.