Important Instructions - auna W2-AC200 Manual Del Usuario

5. Input sensitivity control
• Adjust the input sensitivity to match the output signal of the car radio.
6. Connecting the speakers (stereo & mono)
• Connect the speakers as shown in the illustration.

Important instructions

• The amplifier requires 7.5A at maximum power. If the amplifier is being
used while the engine is switched off, the battery may be discharged.
Please always switch on the motor before using the amplifier.
• Only use power cables with a suitable cross-section (larger than 3 mm
• This device is suitable for speakers with an impedance of 2-16 ohms. The
speakers must have enough capacity to accommodate the power of the
device.
).
2
EN
15