Uline PolyJohn H-8883 Manual Del Usuario página 2

SOAP DISPENSER
To fill soap dispenser, open it by turning lid counterclockwise
and lift up. (See Figure 3) Fill with up to 30 fluid ounces of liquid
soap. Place lid back on and turn clockwise to lock lid in place.
To remove dispenser for cleaning, remove the lid and locate
the tab on middle of mounting plate at rear of dispenser. Push
in on it and slide dispenser up and off. The lid can be secured
back on dispenser for storage. Recommended soap is Uline
Model No. S-17081.
CLEANING
Use a mild soap to clean all surfaces and component
parts.
Minor scratches and abrasions can be lightly sanded
or scrubbed with a mild abrasive cleaner that contains
calcium carbonate, hypochlorate bleach and
detergents. Follow the cleaning product directions since
these ingredients may cause hazardous gases when
mixed with other chemicals. Rinse the cleaned area
and buff with a conventional wax.
PAGE 2 OF 6
OPERATION CONTINUED
MAINTENANCE
WINTERIZING
• Drain all water from the tanks.
• Flush tank with a solution of chlorine and water.
• Depress the foot pump to run chlorine solution
• Drain all water from tanks. While drains are open,
1-800-295-5510
uline.com
Figure 3
through lines.
continue to pump foot pumps to clear all liquids
from lines.
0920 IH-8883