Sinji SMART AIR Manual Del Usuario página 14

It is difficult to clear the air
pollution.
The indoor air is polluted, but
machine does not work at the
highest speed
Q1: Control panel does not turn on.
Al: Please check that there's a power supply: power cord is plugged-in; or the
front cover is properly closed.
Q2: Filter LED is blinking?
A2: Filter has reached its usage cycle. Replace with new filter
Q3 Why is the operational noise is getting louder?
A3: The filter has accumulated too much dust. Clean the pre-filter or the filter.
Q4: Why I cannot turn-on the machine, but there's a bell sound during power
plug-in?
A4: Check to see if the front panel is properly installed. The device was built will
sensor that if there's no front cover or if it isn't not properly installed, the purifier
will be disabled.
Filter Is not working?
Clean the pre/filter
If the situation has not improved, please
replace with new 4in1 filter.
Machine placed in a not suitable area to
remove the pollutants?
Change the machine´s location, or change
fan speed to its highest setting.
14