Sinji SMART AIR Manual Del Usuario página 8

Speed
Wind speed; wind speed is divided into three speeds. There is a corresponding
wind speed icon on the control panel.
Anion
In the power-on state, soft touch the "Anion" key and the on-screen "Anion" light
will flicker. Flickering key means it is active.
Child lock
In the power-on state, touch "Child lock" for 3 seconds to activate. Touch it again
for 3 seconds to Unlock.
UV
In the power-on state, touch "UV" to activate and its light will flicker. Touching it
again will turn it off.
Reset
If it works more than 4000 hours, the "Filter" light will flicker as a reminder to
replace a new filter. After installing a new filter, press the "Reset" kig for 5 seconds.
Then the flickering "Filter" light will be dissapear.
Filter installation sequence:
1. Pre-filter
2. HEPA, Carbon
Replacement procedures:
1. Open the front cover
2. Take out of the old filters
3. Install the new Filters in sequence
4. Press the speed button + timer.
5. Close the upper cover to complete the replacement
8