Publicidad
Idiomas disponibles
Idiomas disponibles
L-EXTENSION
1.
Insert adjustable feet (1) into leg (2) and L-leg (6) and
slide into place at desired height. Insert locking tabs if
desired.
2. Leave legs upside down and space 41" apart.
3. Attach 48" stringer (7) to table legs using center
four holes in back legs. Fasten with eight bolts, lock
washers and nuts.
Figure 1
Not
pre-drilled
Figure 2
Not
pre-drilled
Figure 3
PAGE 2 OF 9
LEGS AND FRAME ASSEMBLY CONTINUED
NON-STEEL TOP ASSEMBLY
NOTE: Attach L-leg (6) to left side of stringer for
right side L-table configuration. Attach to right
side of stringer for left side configuration.
4. Place 48" tabletop (8) on a smooth, non-marring
surface with top side facing down.
5. Align assembled frame with the pre-drilled holes on
the bottom side of the top.
NOTE: See page 3 for steel top assembly.
BASE TABLE
1.
Using 16 wood screws, attach legs to the underside
of the 72" top (5) through pre-drilled holes.
(See Figure 1)
2. Set bench assembly upright and recheck all nuts,
bolts and screws for tightness.
L-EXTENSION
1.
Using 17 wood screws, attach L-leg (6) and leg (2) to
the underside of 48" top (8) through pre-drilled holes.
(See Figures 1 and 2)
NOTE: For L-Extension and L-Table, five holes
on long end of L-leg will not be pre-drilled. If
desired, pilot holes can be created using a drill
and 3/16" drill bit. Hole should be no deeper
than 3/4".
2. Set bench assembly upright and recheck all nuts,
bolts, and screws for tightness.
NOTE: Do not lean on table. You may need to
prop up corner without leg until table is fully
assembled.
L-TABLE
1.
With both table assemblies upright, slide L-extension
underneath base table on right or left hand side.
Make sure that table corners align perfectly.
(See Figure 3)
2. Using five wood screws, attach L-leg (6) to underside
of 72" top (5).
0221 IH-8404
Publicidad
